Hot water circulator
Circulation the hot water up to +80℃ with high accuracy ± 0.5℃ . Various customized such as heater output and pump capacity upon the request. Heater output: 24.0kW
Applications●Hot water circulation to molding machine,Semiconductor manufacturing equipment, HVAC etc.
●A source of heat load for equipment testing.
Hot water circulator with high accuracy. Various customized such as heater output and number of pumps etc.Heating temperature control with high accuracy ± 0.1℃ in temperature range 40℃ to 80℃ . Various customized such as heater output and number of pumps, piping material, etc. based on the following models.
Please feel free to contact us.
Examples of CustomizationThe standard model of Hot water circulator HC series is equipped withonly Heating function.
1) The primary cooling water is required when cooling function added.
The cooling function can be added to by increasing the cooling coils into the water bath when the steps to lower the temperature are required.
Recommended when lower the tank temperature earlier than waiting for natural cooling.
※The primary cooling water is required when cooling function added. Please contact us for more information.
Examples of Customization
2) Addition of Pump (up to 4 units) and Steam trap.
Standard is One unit. Up to 4 units as an option.
Reduce steam to the indoor can be by adding a steam trap.
※ The external dimensions might be changed depending on the number of pumps.
|Control accuracy||PID controller, ±0.5℃ (*2)|
|Pump ability（50/60Hz）||Maximum discharge pressure: 0.59MPa|
Flow rate: 42/55 L/min (*3)
Motor output: 0.75kW
|Water bath capacity (at 80% water level)||110L|
|Safety device/function||Short/Over current breaker, Phase-reversal relay, Warning and Cut off for low water, Circulating water high temperature, Pump over-current, Overheating protection|
|Connecting pipe diameter (Circulating fluid in/out)||Rc1|
|Power Supply (three phase AC200V, 50/60Hz)||100A|
|(*1)The lower limit might be changed depending on operating conditions. Cannot be used for applications circulating water return temperature increases.|
|(*2)Capacity when using tap water. The value when the discharge pressure at 0.3MPa.|
|●The sensitivity current in ELCB should be set larger than 30 mA.|
|●The primary cooling water is required when cooling function added. The cooling capacity depends on the cooling water conditions (Water temperature and Flow rate).|
|●The fee for Delivery, Installing, Piping work and Wiring work are quoted separately.|