Hot water circulator
Circulation of hot water up to +80℃ with high accuracy ±0.5℃. Various customized options such as heater output and pump capacity upon the request.
Applications●Hot water circulation to molding machine, Semiconductor manufacturing equipment, HVAC, etc.
●A source of heat load for equipment testing
Down Load（Useful Information）Taitec general catalog-Hot water circulator HC series（PDF）
Hot water circulator with high accuracy. Various customized such as heater output and number of pumps, etc.Heating temperature control with high accuracy ± 0.5℃ in temperature range 40℃ to 80℃. Various customized options such as heater output, number of pumps, piping material, etc. based on the following models.
Please feel free to contact us.
Examples of Customization
1) The primary cooling water is required when the cooling function is added.
The standard model of the Hot water circulator HC series is equipped with only the Heating function.
The cooling function can be added by increasing the cooling coils into the water bath when the steps to lower the temperature are required.It is recommended to lower the tank temperature earlier than waiting for natural cooling.
※The primary cooling water is required when the cooling function added. Please contact us for more information.
Examples of Customization
2) Addition of Pump (up to 4 units) and Steam trap.
The standard is One unit. Up to 4 units as an option.Indoor steam can be reduced by adding a steam trap.
※ The external dimensions may be changed depending on the number of pumps.
|Temperature range||+40℃ to +80℃(*1)|
|Control accuracy||PID controller, ±0.5℃ (*2)|
|Pump ability（50/60Hz）||Maximum discharge pressure: 0.59MPa|
Flow rate: 42/55 L/min (*3)
Motor output: 0.75kW
|Water bath capacity (at 80% water level)||110L|
|Safety device/function||Short/Over current breaker, Phase-reversal relay, Warning and Cut off for low water, Circulating water high temperature, Pump overcurrent, Overheating protection|
|Connecting pipe diameter (Circulating fluid in/out)||Rc1|
|External dimensions||627×772×1130H mm|
|Power Supply (three phase AC200V, 50/60Hz)||60A|
|(*1)The lower limit may change depending on operating conditions. Cannot be used for applications circulating water return temperature increases.|
|(*2)Capacity when using tap water. The value when the discharge pressure at 0.3MPa.|
|●The sensitivity current in ELCB should be set larger than 30 mA.|
|●The primary cooling water is required when the cooling function added. The cooling capacity depends on the cooling water conditions (Water temperature and Flow rate).|
|●The fee for Delivery, Installing, Piping work and Wiring work are quoted separately.|